Skip to content
Search RD CUSTOMZ

Language

Cart, 1 item

Replacing the Volvo letters on your tailgate: step by step

The Volvo letters on your tailgate are held by adhesive tape only. Swapping them for new chrome silver or matte black letters takes about half an hour and needs no drilling. Work in the shade, preferably at 15 °C or warmer: the old adhesive then softens more easily and the new adhesive grips better.

1. What you need

  • a hair dryer, or a heat gun on its lowest setting
  • fishing line or dental floss
  • a plastic scraper or an old bank card
  • adhesive remover
  • isopropyl alcohol and a clean microfibre cloth
  • masking tape

2. Mark every letter

With five separate letters, marking is the most important step. Stick one long strip of masking tape along the bottom edge of all the letters, and a short upright strip against the left edge of each letter. These marks give you the height, the line and the spacing for the new set.

3. Remove the old letters

Warm one letter at a time for about 30 seconds, until it feels warm but not hot. Slide the fishing line behind it and saw gently back and forth, keeping the line flat against the paint. Never lever against the paint with a screwdriver.

4. Clean the paint

Warm the adhesive residue again and roll it off with your thumb or the plastic scraper. Dissolve what is left with adhesive remover, then wipe the area with isopropyl alcohol so that no wax, polish or grease remains. Leave your masking-tape marks in place.

5. Stick on the new letters

  • Hold each letter in place with the protective film still on to check the position.
  • Peel off the film without touching the adhesive.
  • Start with the L in the middle and work outwards.
  • Press each letter on firmly for about 30 seconds.

6. Let the adhesive set

Remove the masking tape. Keep the car out of the car wash for at least 24 hours, and keep a pressure washer away from the letters for the first few days.

Where it usually goes wrong

  • No marks. Once the adhesive touches the paint, a crooked or badly spaced letter is hard to move.
  • Cold or dirty paint. Adhesive grips poorly on cold paint or on wax. Clean with alcohol, and work in a garage when it is cold outside.
  • Wrong size. Measure first with our measuring guide.

Further reading: Chrome silver or matte black? · View the letters

Cart (1)

Subtotal$45.00

Including VAT. Shipping is calculated at checkout.

View cart

Search

Your legal guarantee rights

EU notice on the legal guarantee of conformity
Open full size

More information: europa.eu/youreurope/guarantees

My car

Loading cars…