Skip to content
Search RD CUSTOMZ

Language

Cart, 0 items

Replacing the Audi rings on your tailgate: step by step

On most Audis the rear rings are held only by adhesive tape. Swapping them for gloss black rings takes about half an hour and needs no drilling. Work in the shade and preferably at 15 °C or warmer: the old adhesive then softens more easily and the new adhesive grips better.

1. What you need

  • a hair dryer, or a heat gun on its lowest setting
  • fishing line or dental floss
  • a plastic scraper or an old bank card
  • adhesive remover
  • isopropyl alcohol and a clean microfibre cloth
  • masking tape

2. Mark the position

Before you remove anything, stick strips of masking tape along the top edge and one side of the old rings. They show exactly where the new emblem goes, level and centred.

3. Remove the old rings

Warm the rings and the paint around them for about a minute until they feel warm, not hot. Slide the fishing line behind one end and saw gently back and forth behind the emblem, keeping the line flat against the paint. Lift the rings off by hand. Never lever against the paint with a screwdriver.

4. Remove the adhesive residue

Warm the residue again and roll it off with your thumb or the plastic scraper. Dissolve what is left with adhesive remover, then clean the area with isopropyl alcohol so that no wax, polish or grease remains.

5. Stick on the new rings

  • Hold the emblem in place with the protective film still on to check the position.
  • Peel off the film without touching the adhesive.
  • Line the emblem up with your masking-tape marks and press it on, starting in the middle and working outwards.
  • Press firmly over the whole emblem for about 30 seconds.

6. Let the adhesive set

Remove the masking tape. Keep the car out of the car wash for at least 24 hours, and keep a pressure washer away from the emblem for the first few days.

Where it usually goes wrong

  • Wrong size. Measure your current rings before you order. Our size guide shows which models use 192 or 202 mm.
  • Cold or dirty paint. Adhesive grips poorly on cold paint or on wax. Clean with alcohol, and work in a garage when it is cold outside.
  • Crooked emblem. Once the adhesive touches the paint, it is hard to move. Use the masking-tape marks and take your time lining it up.

Further reading

Black rear rings 192 / 202 mm · Size guide · All emblems · Contact

Cart (0)

Your cart is empty

Continue shopping

Search

Your legal guarantee rights

EU notice on the legal guarantee of conformity
Open full size

More information: europa.eu/youreurope/guarantees

My car

Loading cars…