Replacing the Audi rings on your front grille: step by step
The four rings on the front of your Audi are held by plastic clips at the back of the grille. Swapping them for gloss black rings takes no special parts, but it does take care: the clips are stiff, and prying the old rings out from the front can easily break a clip or mark the grille. Below is the method that causes the least damage.
1. What you need
- Plastic trim tools and a small flat screwdriver
- Torx bits (on the A4 B8, for example, the grille is held with T25 screws)
- A soft blanket or towel to lay the bumper or grille on
- A microfibre cloth and some soapy water
2. Get to the back of the grille
On most models you can only reach the clips from behind. Owners of the A4 B8, for example, describe taking off the front bumper and then the grille, after which the rings can be removed on the workbench. Removing a bumper is a common DIY job, but the steps differ per model: follow a guide for your exact model, or have a garage or car wrapping shop do it.
Some owners manage to get the rings out from the front with thin plastic tools, but the clips are tight and there is little room behind the rings. Only try this if you accept the risk of a broken clip or marks on the grille.
3. Unclip the old rings
- Lay the grille face down on the towel.
- Find the clips on the back of the rings. On the A4 B8 there are ten.
- Gently push each clip of the grille away from the rings with a small screwdriver, working your way around, until the rings come loose.
- Do not force a clip that will not move; check whether the rings are still hooked somewhere else.
4. Fit the black rings
- Clean the recess in the grille with soapy water and let it dry.
- Line up the clips of the new rings with the mounting points and press the rings in evenly until every clip clicks into place.
- Check from the front that the rings sit flush all the way around.
- Refit the grille and bumper in reverse order and check that all panel gaps are even.
5. Before you start
Measure your current rings first: ours are 273 × 96 mm. The size guide shows which models use this size. If your car has parking sensors, a front camera or headlight washers in the bumper, carefully disconnect the plugs and hoses before you put the bumper aside.
Further reading
Black grille rings 273 mm · Size guide · Audi A3 8V · Audi A4 B8 and B9 · Audi A5 · All emblems · Contact
Sources: Audizine forum, “Audi A4 B8 Bumper Removal / Grille Replacement Guide” (grille removal and the ten clips behind the rings) and owner discussions about removing the front rings; RS246 forum, owner discussion about removing the front badge.